LevelOne Infinity IES-0880 User Manual page 86

Use no storm-control multicast command to disable multicast traffic.
3. Command Syntax:
storm-control multicast enable
no storm-control multicast
4. Example:
The following example shows setting storm-control multicast enable to the interface fe1
(port 1):
switch_a(config)#interface fe1
switch_a(config-if )#storm-control multicast enable
switch_a(config-if )#
DLF:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if )#
2. Usage:
Use storm-control dlf enable command to enable destination lookup failure traffic.
Use no storm-control dlf command to disable destination lookup failure traffic.
3. Command Syntax:
storm-control dlf enable
no storm-control dlf
dlf destination lookup failure
4. Example:
The following example shows setting storm-control dlf enable to the interface fe1 (port
1):
switch_a(config)#interface fe1
switch_a(config-if )#storm-control dlf enable
switch_a(config-if )#
Static MAC Entry
Static-MAC-Entry Forward:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
IES-0880 User Manual Page 86