LevelOne Infinity IES-0880 User Manual page 118

no snmp-server community get
NAME The get community name for SNMP.
4. Example:
The following example specifies get community name (name) for SNMP:
switch_a(config)#snmp-server community get name
switch_a(config)#
Set Community Name:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use snmp-server community set command to specify and no snmp-server community
set command to remove set community name for SNMP.
3. Command Syntax:
snmp-server community set NAME
no snmp-server community set
NAME The set community name for SNMP.
4. Example:
The following example specifies set community name (name) for SNMP:
switch_a(config)#snmp-server community set name
switch_a(config)#
SNMP v3
SNMPv3 No-Auth:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Add a user using snmp v3 with read-only or read-write access mode and without
authentication. Use the no form of the command to delete this user.
3. Command Syntax:
(no) snmp-server v3-user USERNAME (ro｜rw) noauth
USERNAME Specify a user name.
ro read-only access mode
IES-0880 User Manual Page 118