LevelOne Infinity IES-0880 User Manual page 104

disable Sets VLAN into a disable state.
4. Example:
The following example enables the vlan VLANID (2) and name VLAN_NAME (vlan2) of
bridge GROUP (1):
switch_a(config-vlan)#vlan 2 bridge 1 name vlan2 state enable
switch_a(config-vlan)#
802.1Q Port Setting
Switchport mode access:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if )#
2. Usage:
Use switchport mode access command to set the switching characteristics of the Layer-2
interface to access mode, and classify untagged frames only.
Use the no switchport access command to reset the mode of the Layer-2 interface to
access (default).
3. Command Syntax:
switchport mode access
no switchport access
4. Example:
The following example sets the switchport mode access of the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if )#switchport mode access
switch_a(config-if )#
Switchport mode hybrid:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if )#
IES-0880 User Manual Page 104