LevelOne Infinity IES-0880 User Manual page 117

authentication failure trap for SNMP.
3. Command Syntax:
(no) snmp-server trap-type enable authenticationFailure
4. Example:
The following example enables authentication failure trap for SNMP:
switch_a(config)#snmp-server trap-type enable authenticationFailure
switch_a(config)#
Topology Change Trap:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use snmp-server trap-type enable topologyChange command to enable topology
change trap for SNMP.
Use the no snmp-server trap-type enable topologyChange command to disable
topology change trap for SNMP.
3. Command Syntax:
(no) snmp-server trap-type enable topologyChange
4. Example:
The following example enables topology change trap for SNMP:
switch_a(config)#snmp-server trap-type enable topologyChange
switch_a(config)#
SNMP v1/v2c
Get Community Name:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use snmp-server community get command to specify and no snmp-server community
get command to remove get community name for SNMP.
3. Command Syntax:
snmp-server community get NAME
IES-0880 User Manual Page 117