I Scan Resume Condition - Icom IC-V8000 Instruction Manual

I Scan resume condition

The scan resume condition can be selected as timer, pause
or empty pause scan. The empty pause scan is useful for
finding unused channels. The selected resume condition is
also used for priority watch. (p. 00)
q Push [SET(LOCK)] to enter set mode.
w Push [SET(LOCK)] or [MW(S.MW)] several times until
"SCT" or "SCP" appears as shown above.
• Cancel the DTMF memory encoder in advance, if necessary.
(p. 00)
e Rotate the tuning dial to set the desired timer:
• "SCT-15" : Scan pauses 15 sec. while receiving a signal.
• "SCT-10" : Scan pauses 10 sec. while receiving a signal.
• "SCT-5" : Scan pauses 5 sec. while receiving a signal.
• "SCP-2" : Scan pauses until the signal disappears and then
resumes 2 sec. later.
r Push [V/MHz(SCAN)] to exit set mode.
SET MODE
USING
The display shows that the
scan will resume 15 sec.
after it stops.
z Push [
B(D-OFF)] to enter set mode.
SET
SET
x Push [
B(D-OFF)] or [
SET
B
times until "SCT" or "SCP" appears as shown at
left.
• Cancel the DTMF memory encoder in advance, if
necessary. (p. 00)
c Push [Y] or [Z] to select the scan resume condi-
tion.
• See item e at left for scan resume condition details.
v Push [
A(MW)] to exit set mode.
CLR
NOTE:
SET mode cannot be accessed when memory names are
displayed. To set the scan resume condition, return to
channel number indication by pushing [MONI(ANM)] on
the front panel for 1 sec., or push [FUNC] then
[ 1(ANM)] to cancel the channel name indication, then
MONI
set as describes above.
SCAN OPERATION
C(T-OFF)] several
ENT
8
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
42