Chapter 3 Quick Operating Guide; Wiring; Setting The Protocol And Baud Rate; Setting The Device Address - Genie GSD106 User Manual

Chapter 3 - Quick Operating Guide
I. Wiring
. Setting Protocol and Baud Rate
II
Protocol
Setting
The figure shows: Protocol: PELCO-D
Baud rate: 2400 bps
III. Setting Dome Address
Set address for Dome
IV. Install Camera
Note :
1. Do not connect the camera and dome with FFC in an incorrect manner.
2.The installation fixing holes of for different camera may differ.
BNC Video Output
Red
Black
Orange RS485A (+)
Yellow RS485B (-)
Yellow-Green Interphase Colour
Yellow-Green Interphase Colour
External Connection for Alarm Input/Output
Turn the power Off when setting, and restart the dome after revision
Baud Rate
Setting
(Refer to detailed parameters in the next chapter)
(Refer to detailed parameters in the next chapter)
This dip switch is located on the PCB in the dome
Display
AC24V Input
Controller of
the Dome
The figure shows: A Dome Address of 1
5
Power Supply of Dome
Connected to
Ground
Protocol
Baud Rate
Setting
Setting
The figure shows: Auto detection protocol.
Baud rate: 2400bps