Super Filter - Roland SBX-1000 Owner's Manual

00: THRU
The effect won't be applied.

01: SUPER FILTER

This is a filter with an extremely sharp slope. The cutoff frequency can be varied cyclically.
Knob Parameter
Filter Type
Slope
[Knob 3] Cutoff
[Knob 2] Resonance
Modulation Sw
Modulation Wave
Rate BPM Sync
Rate
[Knob 1] Depth
Level
2
Value Explanation
LPF, BPF, HPF, NOTCH Filter type
Frequency range that will pass through each filter
LPF: Frequencies below the cutoff
BPF: Frequencies in the region of the cutoff
HPF: Frequencies above the cutoff
NOTCH: Frequencies other than the region of the cutoff
-12 dB, -24 dB, -36 dB Filter slope (damping characteristics; amount of damping per octave)
-12 dB: gentle
-24 dB: steep
-36 dB: extremely steep
0–127 Cutoff frequency of the filter
Increasing this value will raise the cutoff frequency.
0–127 Filter resonance level
Increasing this value will emphasize the region near the cutoff frequency.
OFF, ON On/off switch for cyclic change
TRI, SQR, SIN, SAW1, How the cutoff frequency will be modulated
SAW2
TRI: triangle wave
SQR: square wave
SIN: sine wave
SAW1: sawtooth wave (upward)
SAW2: sawtooth wave (downward)
OFF, ON OFF: Rate specified as numerical value
ON: Rate specified as note value
0–127, note Rate of modulation
0–127 Depth of modulation
0–127 Output level
SAW1 SAW2