Step Phaser; Infinite Phaser - Roland SBX-1000 Owner's Manual

23: STEP PHASER

This is a stereo phaser. The phaser effect will be varied gradually.
Knob Parameter
Mode
[Knob 2] Manual
Rate BPM Sync
Rate
Depth
Polarity
[Knob 3] Resonance
Step Rate BPM
Sync
[Knob 1] Step Rate
Wet Low Gain
Wet High Gain
Mix
Level

24: INFINITE PHASER

A phaser that continues raising/lowering the frequency at which the sound is modulated.
Knob Parameter
Mode
[Knob 1] Speed
[Knob 2] Resonance
[Knob 3] Depth
Pan
Low Gain
High Gain
Level
14
Value Explanation
4-STAGE, 8-STAGE, Number of stages in the phaser
12-STAGE
0–127 Adjusts the basic frequency from which the sound will be modulated.
OFF, ON OFF: Rate specified as numerical value
ON: Rate specified as note value
0–127, note Frequency of modulation
0–127 Depth of modulation
INVERSE, SYNCHRO Selects whether the left and right phase of the modulation will be the same or the
opposite.
INVERSE: The left and right phase will be opposite. When using a mono source,
this spreads the sound.
SYNCHRO: The left and right phase will be the same. Select this when inputting a
stereo source.
0–127 Amount of feedback
OFF, ON OFF: Step Rate specified as numerical value
ON: Step Rate specified as note value
0–127, note Rate of the step-wise change in the phaser effect
-15–+15 dB Amount of boost/cut for the effect sound's lower range
-15–+15 dB Amount of boost/cut for the effect sound's upper range
0–127 Level of the phase-shifted sound
0–127 Output Level
Value Explanation
1, 2, 3, 4 Higher values will produce a deeper phaser effect.
-100–+100 Speed at which to raise or lower the frequency at which the sound is modulated
(+: upward / -: downward)
0–127 Amount of feedback
0–127 Depth of modulation
L64–63R Panning of the output sound
-15–+15 dB Amount of boost/cut for the low-frequency range
-15–+15 dB Amount of boost/cut for the high-frequency range
0–127 Output Level