Roland SBX-1000 Owner's Manual page 12

19: CHORUS
This is a stereo chorus. A filter is provided so that you can adjust the timbre of the chorus sound.
Knob Parameter
Filter Type
Cutoff Frequency
Pre Delay
Rate BPM Sync
[Knob 1] Rate
[Knob 2] Depth
Phase
Wet Low Gain
Wet High Gain
[Knob 3] Balance
Level
20: HEXA-CHORUS
Uses a six-phase chorus (six layers of chorused sound) to give richness and spatial spread to the sound.
Knob Parameter
Pre Delay
Rate BPM Sync
[Knob 1] Rate
Depth
Pan Deviation
[Knob 2] Balance
[Knob 3] Level
12
Value Explanation
OFF, LPF, HPF Type of filter
OFF: no filter is used
LPF: cuts the frequency range above the Cutoff Freq
HPF: cuts the frequency range below the Cutoff Freq
200–8000 Hz Center frequency when using the filter to cut a specific frequency range
0.0–100 msec Adjusts the delay time from the direct sound until the chorus sound is heard.
OFF, ON OFF: Rate specified as numerical value
ON: Rate specified as note value
0–127, note Frequency of modulation
0–127 Depth of modulation
0–180 deg Spatial spread of the sound
-15–+15 dB Amount of boost/cut for the effect sound's lower range
-15–+15 dB Amount of boost/cut for the effect sound's upper range
D100:0W–D0:100W Volume balance between the direct sound (D) and the chorus sound (W)
0–127 Output Level
Value Explanation
0.0–100 msec Adjusts the delay time from the direct sound until the chorus sound is heard.
OFF, ON OFF: Rate specified as numerical value
ON: Rate specified as note value
0–127, note Frequency of modulation
0–127 Depth of modulation
0–20 Adjusts the difference in stereo location between each chorus sound.
0: All chorus sounds will be in the center.
20: Each chorus sound will be spaced at 60 degree intervals relative to the center.
D100:0W–D0:100W Volume balance between the direct sound (D) and the chorus sound (W)
0–127 Output Level