Roland SBX-1000 Owner's Manual page 7

10: ISOLATOR
This is an equalizer which cuts the volume greatly, allowing you to add a special effect to the sound by cutting the volume in
varying ranges.
Knob Parameter
[Knob 1] Boost/Cut Low
[Knob 2] Boost/Cut Mid
[Knob 3] Boost/Cut High
Mode
11: SLICER
By applying successive cuts to the sound, this effect turns a conventional sound into a sound that appears to be played as a
backing phrase. This is especially effective when applied to sustain type sounds.
Knob Parameter
[Knob 3] Level Modify
Level Step 1-8
Rate BPM Sync
[Knob 1] Rate
[Knob 2] Attack
Input Sync Sw
Input Sync
Threshold
Mode
Shuffle
Level
Value Explanation
-64–+63 These boost and cut each of the Low frequency ranges.
At -64, the sound becomes inaudible. 0 is equivalent to the input level of the
sound.
-64–+63 These boost and cut each of the Middle frequency ranges.
At -64, the sound becomes inaudible. 0 is equivalent to the input level of the
sound.
-64–+63 These boost and cut each of the High frequency ranges.
At -64, the sound becomes inaudible. 0 is equivalent to the input level of the
sound.
BOOST NORMAL, Maximum value of the boost
BOOST HIGH
NORMAL: +4dB
HIGH: +12dB
Value Explanation
0–127 Increases value for all steps
0–127 Level at each step
OFF, ON OFF: Rate specified as numerical value
ON: Rate specified as note value
0–127, note Rate at which 8-step sequence is to be repeated
0–127 Speed at which the level changes between steps
OFF, ON Specifies whether an input note will cause the sequence to resume from the first
step of the sequence (ON) or not (OFF)
0–127 Volume at which an input note will be detected
LEGATO, SLASH Sets the manner in which the volume changes as one step progresses to the next.
LEGATO: The change in volume from one step's level to the next remains
unaltered. If the level of a following step is the same as the one preceding it, there
is no change in volume.
SLASH: The level is momentarily set to 0 before progressing to the level of the
next step. This change in volume occurs even if the level of the following step is
the same as the preceding step.
0–127 Timing of volume changes in levels for even-numbered steps (step 2, step 4, step
6...).
The higher the value, the later the beat progresses.
0–127 Output level
7