Operation Using The Remote - Rinnai Arriva 752 Operation Manual

Operation using the remote

For the remote control functions to be available, the appliance On/Off button must be in the
on position.
General information about the
remote control
The remote control emits an infra-
red signal. It must be aimed at the
receiver unit located on the right
side of the unit, normal operating
range is 5 m. Some fluorescent
lights may interfere with the
transmission of the remote signal.
If you experience this problem,
changing position from which
you are operating the remote may
help.
unless the remote display is
deactivated or the lock function is
activated, the remote control will
transmit information to the heater
every time a button is pressed.
when the timers are being set,
information is transmitted only
when the 'Time Set' button is
pressed.
when the remote is not used for
a period of approximately five
seconds, the display will default
to standby mode, displaying only
the time. To reactivate press any
button on the keypad.
Signal transmissions
Signal transmissions are
confirmed by a brief
illumination of the signal
indicator on the remote.
The unit will also flash and beep
to confirm the settings have been
received.
Batteries
The remote uses
two x 1.5 v AAA
batteries. Never
mix old and new
batteries.
Remove the batteries if the remote
is not going to be used for a long
time. This will help avoid damage
from leaking batteries.
After battery replacement the
clock and timers may need to be
reprogrammed.
Turning the heater on
when the heater is in standby
mode, pressing the Standby/
On button will start the ignition
sequence and the LED will glow
red to indicate that the heater is
operating.
Turning the heater to standby
Press the Standby/On button. This
will turn off the unit and the LED
will glow green to indicate the
appliance is in standby.
Standby/On
Stops and operates the heater remotely.
Flame
Sets the flame picture.
Extra low
Energy saving room temperature control.
Lock
Locks out control to prevent tampering.
Timer 1
Sets timer program 1.
Timer 2
Sets timer program 2.
Override
Manually overrides current timer
operation.
Time Set
Sets clock and timers.
Adjusting the temperature
Pressing the up and down buttons
will change the preset temperature
by increments of 1 °C—the
temperature will be displayed on
the remote.
The temperature can be preset to:
• L (low) - continuous
combustion on low
16~26 °C (in 1 °C) steps
•
- combustion rate varies
to maintain the selected
temperature
• H (high) - continuous
combustion on high
Arriva 752 Operation Guide: 12219-A 01-12 | 9