Operation Using Your Remote - Rinnai Linear Series Operation Manual

Operation using the remote
For the remote control functions to be available, the appliance On/Off button must
be in the On position.
Signal transmission to the unit
The unit will beep and flash to confirm the
settings have been received from the remote.
Lost or misplaced remote
If you misplace the remote the fire can still be
used, albeit in a limited capacity
the power On/Off button on the lower left
hand corner of the outer frame. The fire will
automatically modulate between flame settings
to maintain the default set temperature of 22
°C.
Remote - safety
Keep the remote away from young
children. Also ensure they can't access
the batteries—they can become a
WARNING
choke hazard and potentially life-
threatening if swallowed.
Breakage of the plastic housing could expose
sharp edges—replace the remote if this occurs.
Avoid getting the remote wet as water entry will
damage the remote.
Batteries
The remote uses two Lithium cell CR2450
batteries. Never mix old and new batteries.
The remote will be supplied with the batteries
already inserted, pull the clear tab to activate
(OH, meaning OK, will flash on the display).
This will also occur when the batteries have
been replaced.
Remove the batteries if the remote is not going
to be used for a long time. This will help avoid
damage from leaking batteries. If leakage has
occurred the remote will need to be replaced as
leaking chemicals could be a risk if touched or
ingested.
Only applies if you do not operate the Linear using the Wi-Fi app.
1
8 | Linear operation guide: 13562-B 02-19
, by using
1
Pull-tab
Changing the batteries
• Remove the back
Slide your fingernail under the bottom
corner and along the base, and gently pry
apart. With some coaxing the cover will
pop off. Patience required, remember it's
designed so little fingers cannot easily
access the batteries.
• Unscrew the black retaining bridge
Undo the two small screws holding the
black retaining bridge between the two
batteries.
• Replace the batteries
The batteries can only be inserted one
way—printed side facing up as shown on
the next page. The battery contact edges
can be sharp, take care when replacing the
batteries.
• Replace the black bridging plate
Ensure you replace the black bridging plate
as this will reduce the risk of young children
getting access to the cell batteries.
Remove back cover by prising
apart from the bottom first