Operation Using The Remote - Rinnai Ember Series Operation Manual

Operation using the remote

For the remote control functions to be available, the appliance On/Off button
must be in the On position.
Signal transmission to the unit
The unit will beep and flash to confirm the
settings have been received from the remote.
Lost or misplaced remote
If you misplace the remote the fire can still
be used, albeit in a limited capacity, by using
the power On/Off button on the lower
right hand corner of the outer frame. The
fire will automatically modulate between
flame settings to maintain the default set
temperature of 22 °C.
Remote - safety
Keep the remote away from
young children. Also ensure they
can't access the batteries—they
WARNING
can become a choke hazard and
potentially life-threatening if
swallowed.
Breakage of the plastic housing could expose
sharp edges—replace the remote if this
occurs.
Avoid getting the remote wet as water entry
will damage the remote.
Batteries
The remote uses two Lithium cell CR2450
batteries. Never mix old and new batteries.
The remote will be supplied with the batteries
already inserted, pull the clear tab to activate
(OH, meaning OK, will flash on the display).
This will also occur when the batteries have
been replaced.
Remove the batteries if the remote is not
going to be used for a long time. This will
help avoid damage from leaking batteries. If
leakage has occurred the remote will need to
be replaced as leaking chemicals could be a
risk if touched or ingested.
6 | Ember Operation Guide: 12889-A 01-17
Pull-tab
Changing the batteries
• Remove the back
Slide your fingernail under the bottom
corner and along the base, and gently pry
apart. With some coaxing the cover will
pop off. Patience required, remember it's
designed so little fingers cannot easily
access the batteries.
Remove back cover by prising
apart from the bottom first
• Unscrew the black retaining bridge
Undo the two small screws holding the
black retaining bridge between the two
batteries.
• Replace the batteries
The batteries can only be inserted one
way—printed side facing up as shown on
the next page. The battery contact edges
can be sharp, take care when replacing the
batteries.
• Replace the black bridging plate
Ensure you replace the black bridging
plate as this will reduce the risk of young
children getting access to the cell
batteries.