Ssk 400 Protective Dust Cover; Mk 400 Detector Console; Mh 400 Detector Heating Element; External Detector Alarm Display / Remote Indicator - Bosch FCP-320 Operation Manual

Conventional Automatic Detectors
5.4

SSK 400 Protective Dust Cover

The SSK 400 Protective Dust Cover is necessary during
construction work to protect an installed detector base,
with or without upper detector section, from
contamination. The protective dust cover made from
polypropylene (PP) is pushed onto the installed detector
base.
5.5

MK 400 Detector Console

The MK 400 Detector Console is used to install detectors
above door frames or similar in compliance with DIBt.
The console is supplied with a pre-mounted MS 400
Detector Base (the detector shown is not included in the
scope of delivery).
5.6

MH 400 Detector Heating Element

The MH 400 Detector Heating Element is required if the
detector is used in an environment where water
condensation can occur, such as in a warehouse that must
frequently be opened briefly for delivery vehicles.
The detector heating element is connected to the + V/0 V
terminals in the detector base.
Operating voltage: 24 V DC
Resistor: 1 kΩ
Power consumption: 3 W.
The heating is supplied with power either by the looped-
through supply voltage via the control panel or by a
separate power supply unit.
With supply via the control panel, the number of detector
heating elements depends on the cable cross section and
cable length used.
5.7

External Detector Alarm Display / Remote Indicator

An External Detector Alarm Display or Remote Indicator is required if the detector is not
directly visible or has been mounted in false ceilings or floors.
The remote indicators should be installed in corridors or access pathways to the
corresponding building sections or rooms. The red alarm indication of both FAA-420-RI and
MPA correspond to DIN 14623.
Bosch Sicherheitssysteme GmbH Operation Guide
Accessories | en 17
F.01U.002.707 | 8.0 | 2011.10