Mounting The Bases - Bosch FCP-320 Operation Manual

Conventional Automatic Detectors
4.2

Mounting the Bases

The detector bases are screwed to the even, dry surface using two screws approx. 55 mm
apart.
In the case of cable feed for surface mounting, break out the prepared entry points (X) on the
housing.
In the case of flush mounted cable feed, route the cable through the opening in the centre of
the base.
The short mounting bores marked in the sketch with "Y" may be used only for fixing over a
back box.
NOTICE!
Cable feed and outfeed can be on the same side.
For cable feed at the FAA-420-SEAL and MSC 420 puncture the sealing with a pointed tool. Do
not cut the sealing with a knife.
Bosch Sicherheitssysteme GmbH
Ø 120
X
Ø 100
Y
Operation Guide
Installation | en
Y
F.01U.002.707 | 8.0 | 2011.10
11