Enabling And Disabling Parksense; Service The Parksense® Park Assist System - Jeep 2014 Grand Cherokee Owner's Manual

234 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Adjustable Chime Volume Settings
Front and Rear chime volume settings can be selected
from the EVIC or Uconnect® System — if equipped.
If Uconnect® System is equipped, chime volume settings
will not be accessible from the EVIC.
The chime volume settings include LOW, MEDIUM, and
HIGH. The factory default volume setting is MEDIUM.
ParkSense® will retain its last known configuration state
through ignition cycles.
Enabling And Disabling ParkSense®
ParkSense® can be enabled and disabled with the
ParkSense® switch.
When the ParkSense® switch is pressed to
disable the system, the instrument cluster will
display the "PARKSENSE OFF" message for
approximately five seconds. Refer to "Electronic Vehicle
Information Center (EVIC)" in "Understanding Your
Instrument Panel" for further information. When the
shift lever is moved to REVERSE and the system is
disabled, the EVIC will display the "PARKSENSE OFF"
message for as long as the vehicle is in REVERSE.
The ParkSense® switch LED will be ON when
ParkSense® is disabled or requires service. The
ParkSense® switch LED will be OFF when the system is
enabled. If the ParkSense® switch is pressed, and the
system requires service, the ParkSense® switch LED will
blink momentarily, and then the LED will be ON.
Service The ParkSense® Park Assist System
During vehicle start up, when the ParkSense® System
has detected a faulted condition, the instrument cluster
will actuate a single chime, once per ignition cycle, and it
will display the PARKSENSE UNAVAILABLE WIPE
REAR SENSORS , PARKSENSE UNAVAILABLE WIPE