Jeep 2014 Grand Cherokee Owner's Manual page 466

464 STARTING AND OPERATING
The set speed for SSC is selectable by the driver, and can
be adjusted by using the paddle shifter's. Additionally,
the SSC set speed is automatically reduced when climb-
ing a grade and the level of set speed reduction depends
on the magnitude of grade. The following summarizes
the SSC set speeds:
• P = No set speed. SSC may be enabled but will not
activate.
• R = 0.6 mph (1 km/h)
• N = 1.2 mph (2 km/h)
• 1st = 0.6 mph (1 km/h)
• 2nd = 1.2 mph (2 km/h)
• 3rd = 1.8 mph (3 km/h)
• 4th = 2.5 mph (4 km/h)
• 5th = 3.1 mph (5 km/h)
• 6th = 3.7 mph (6 km/h)
• 7th = 4.3 mph (7 km/h)
• 8th = 5.0 mph (8 km/h)
NOTE: During SSC the +/- paddle shifter input is used
for SSC target speed selection and will put the transmis-
sion into ERS but will not affect the gear chosen by the
transmission unless in Driver Override. During SSC the
transmission will shift appropriately for the driver-
selected set speed and corresponding driving conditions.
Driver Override:
The driver may override SSC activation with throttle or
brake application at any time. While in driver override
the transmission will be in ERS which is a top gear limiter
and the vehicle will shift from 1st through whichever
gear is displayed.