Jeep 2014 Grand Cherokee Owner's Manual page 220

218 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To Change The FCW Sensitivity And Active Braking
Settings With Uconnect® 5.0 System Screen — If
Equipped.
Follow these steps to set the FCW Sensitivity and Active
Braking:
1. Press the "+ MORE" hard-key located on the lower
right side of the Uconnect® system.
2. Press the "Settings" soft-key.
3. Press the "Safety/Assistance" soft-key.
4. Press the first "FWD Collision W..." soft-key.
5. Press the "FWD Collision Warning" Far or Near
soft-key for your desired preference. Then press the
back arrow.
6. Press the second "FWD Collision W..." soft-key.
7. Press the "Active Braking" On or Off soft-key.
The default status of FCW is the "Far" setting and the
Active Braking is the "On" setting, this allows the system
to warn you of a possible collision with the vehicle in
front of you when you are farther away and it applies
limited braking. This gives you the most reaction time to
avoid a possible collision.
Changing the FCW status to the "Near" setting, allows
the system to warn you of a possible collision with the
vehicle in front of you when you are much closer. This
setting provides less reaction time than the "Far" setting,
which allows for a more dynamic driving experience.