Service The Parksense® Rear Park Assist System - Jeep 2014 Grand Cherokee Owner's Manual

approximately five seconds. Refer to "Electronic Vehicle
Information Center (EVIC)" in "Understanding Your
Instrument Panel" for further information. When the
shift lever is moved to REVERSE and the system is
disabled, the EVIC will display the "PARKSENSE OFF"
message for as long as the vehicle is in REVERSE.
The ParkSense® switch LED will be ON when
ParkSense® is disabled or requires service. The
ParkSense® switch LED will be OFF when the system is
enabled. If the ParkSense® switch is pressed, and the
system requires service, the ParkSense® switch LED will
blink momentarily, and then the LED will be ON.
Service The ParkSense® Rear Park Assist
System
During vehicle start up, when the ParkSense® Rear Park
Assist System has detected a faulted condition, the
instrument cluster will actuate a single chime, once per
ignition cycle, and it will display the "PARKSENSE
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 225
UNAVAILABLE WIPE REAR SENSORS" or the
"PARKSENSE UNAVAILABLE SERVICE REQUIRED"
message. Refer to "Electronic Vehicle Information Center
(EVIC)" in "Understanding Your Instrument Panel" for
further information. When the shift lever is moved to
REVERSE and the system has detected a faulted condi-
tion, the EVIC will display the PARKSENSE UNAVAIL-
ABLE WIPE REAR SENSORS or PARKSENSE UN-
AVAILABLE SERVICE REQUIRED message for as long
as the vehicle is in REVERSE. Under this condition,
ParkSense® will not operate.
If "PARKSENSE UNAVAILABLE WIPE REAR SEN-
SORS" appears in the Electronic Vehicle Information
Center (EVIC) make sure the outer surface and the
underside of the rear fascia/bumper is clean and clear of
snow, ice, mud, dirt or other obstruction and then cycle
the ignition. If the message continues to appear, see an
authorized dealer.
3