Carrier AQUASNAP 30RB060-390 Controls, Start-Up, Operation, Service And Troubleshooting Instructions page 122

Operating Data:
Record the following information from the Run Status, Temperatures and Outputs Modes when machine is in a
stable operating condition. If cooling load is insufficient, these readings must be obtained by putting the chiller in
test mode (Service Test) and running each compressor.
TEMPERATURES
COOLER ENTERING FLUID
COOLER LEAVING FLUID
CONTROL POINT
CAPACITY
OUTSIDE AIR TEMPERATURE
LEAD/LAG LEAVING FLUID
OPTIONAL HEAT RECLAIM
ENTERING WATER TEMPERATURE
LEAVING WATER TEMPERATURE
Install a manifold gage set to obtain readings and verify these against pressure transducers.
CIRCUIT A
SCT.A __________
SST.A __________
SGT.A __________
SUP.A __________
EXV.A__________
NOTE: EXV A,B,C positions are found in the output mode.
COMPRESSOR MOTOR CURRENT
L1
COMPRESSOR A1 ______
COMPRESSOR A2 ______
COMPRESSOR A3 ______
COMPRESSOR A4 ______
COMPRESSOR B1 ______
COMPRESSOR B2 ______
COMPRESSOR B3 ______
COMPRESSOR B4 ______
COMPRESSOR C1 ______
COMPRESSOR C2 ______
COMPRESSOR C3 ______
COMPRESSOR C4 ______
CONDENSER FAN MOTOR CURRENT
L1
FAN MOTOR 1 ______
FAN MOTOR 2 ______
FAN MOTOR 3 ______
FAN MOTOR 4 ______
FAN MOTOR 5 ______
FAN MOTOR 6 ______
FAN MOTOR 7 ______
FAN MOTOR 8 ______
FAN MOTOR 9 ______
EWT _______________
LWT _______________
CTPT _______________
CAP _______________
OAT _______________
CHWS_______________ (Dual Chiller Control Only)
HEWT _______________
HLWT _______________
CIRCUIT B
SCT.B __________ SCT.C___________
SST.B __________ SST.C ___________
SGT.B __________ SGT.C ___________
SUP.B __________ SUP.C ___________
EXV.B __________ EXV.C ___________
L2 L3
______ ______
______ ______
______ ______
______ ______
______ ______
______ ______
______ ______
______ ______
______ ______
______ ______
______ ______
______ ______
L2 L3
______ ______
______ ______
______ ______
______ ______
______ ______
______ ______
______ ______
______ ______
______ ______
CL-8
CIRCUIT C
L1
FAN MOTOR 10 ______
FAN MOTOR 11 ______
FAN MOTOR 12 ______
FAN MOTOR 13 ______
FAN MOTOR 14 ______
FAN MOTOR 15 ______
FAN MOTOR 16 ______
FAN MOTOR 17 ______
FAN MOTOR 18 ______
L2 L3
______ ______
______ ______
______ ______
______ ______
______ ______
______ ______
______ ______
______ ______
______ ______