Carrier AQUASNAP 30RB060-390 Controls, Start-Up, Operation, Service And Troubleshooting Instructions page 121

SUB-MODE ITEM
QUIC†(cont) CH.A1
CH.A2
CH.A3
CH.A4
CH.B1
CH.B2
CH.B3
CH.B4
CH.C1
CH.C2
CH.C3
CH.C4
HGB.A
HGB.B
HGB.C
Q.RDY
Q.RUN
SHUT
CATO
ALRM
ALRT
C.ALM
*Place the Enable/Off/Remote Contact switch to the Off position prior to configuring T.REQ to ON. Configure the desired item to ON, then
place the Enable/Off/Remote Contact switch to the Enable position.
†Place the Enable/Off/Remote Contact switch to the Off position prior to configuring Q.REQ to ON. The switch should be in the Off position
to perform Quick Test.
MODE — SERVICE TEST (cont)
DISPLAY
OFF/ON Compressor A1 Heater
OFF/ON Compressor A2 Heater
OFF/ON Compressor A3 Heater
OFF/ON Compressor A4 Heater
OFF/ON Compressor B1 Heater
OFF/ON Compressor B2 Heater
OFF/ON Compressor B3 Heater
OFF/ON Compressor B4 Heater
OFF/ON Compressor C1 Heater
OFF/ON Compressor C2 Heater
OFF/ON Compressor C3 Heater
OFF/ON Compressor C4 Heater
OFF/ON Hot Gas Bypass A Output
OFF/ON Hot Gas Bypass B Output
OFF/ON Hot Gas Bypass C Output
OFF/ON Chiller Ready Status
OFF/ON Chiller Running Status
OFF/ON Customer Shut Down Stat
xx.x Chiller Capacity 0-10v
OFF/ON Alarm Relay
OFF/ON Alert Relay
OFF/ON Critical Alarm Relay
CL-7
ITEM EXPANSION ENTRY