Glass Assembly; Screen Mesh; Grilles And Trim; Shutter Settings - Heat & Glo 6000GBV Owner's Manual

F. Glass Assembly
WARNING
Handle glass doors with care.
• Inspect the gasket to ensure it is
undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Any scratch in glass, requires replacement.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door removed,
cracked, broken or scratched.
• Replace glass door assembly as a complete appliance.
Removing Glass Assembly
Pull the four glass assembly latches out of the groove on
the glass frame. Remove glass door from the appliance
(see Figure 12.14).
Replacing Glass Assembly
Replace the glass door on the appliance. Pull out and
latch the four glass assembly latches into the groove on
the glass frame.
L ATCHE S
(BOTH BOT TO M
AND TOP )
GLASS
ASSEMB LY
Figure 12.14 Glass Assembly
28 Heat & Glo • 6000GBV, 6000GBV-IPI • 2104-900 Rev. G • 9/08
G. Screen Mesh
The screen mesh is a supplied with the optional doors.
H. Grilles and Trim
Install optional marble and brass trim surround kits as
desired. Marble, brass, brick, tile, or other non-combustible
materials can be used to cover up the gap between the
sheet rock and the appliance.
Do not obstruct or modify the air inlet/outlet grilles.
I. Shutter Settings
Models
6000GBV
NG LP
1/8 1/4