Tools And Supplies Needed; Inspect Appliance And Components - Heat & Glo 6000GBV Owner's Manual

C. Tools and Supplies Needed
Before beginning the installation be sure that the follow-
ing
tools and building supplies are available.
Reciprocating saw
Pliers
Hammer
Phillips screwdriver
Flat blade screwdriver Electric drill and bits (1/4 in.)
Plumb line
Level
Manometer
Non-corrosive leak check solution
1/2 - 3/4 inch length, #6 or #8 Self-drilling screws
One 1/4 inch female connection (for optional fan).
D.

Inspect Appliance and Components

WARNING
Inspect appliance and components for
damage. Damaged parts may impair safe
operation.
• Do NOT install damaged components.
• Do NOT install incomplete components.
• Do NOT install substitute components.
Report suspected damaged parts to dealer.
The following B-vent components are needed for instal-
lation (see Figure 2.2).
• Fireplace Box
• Pipe Components
• Firestops
• Attic Insulation Shield
• Elbows
• Strapping
• Roof Flashing or Chase Top
• Termination Cap
• Storm Collar
• Carefully remove the appliance and components from
the packaging.
• The vent system components and trim doors are shipped
in separate packages.
• The gas logs may be packaged separately and must
be fi eld installed.
• Report to your dealer any parts damaged in shipment,
particularly the condition of the glass.
8
Framing material
Hi temp caulking material
Gloves
Framing square
Safety glasses
Tape measure
Voltmeter
Heat & Glo • 6000GBV, 6000GBV-IPI • 2104-900 Rev. G • 9/08
VE R T IC A L TE R M IN A T IO N C A P
S T O R M C O L L A R
R O O F F L A S H IN G
O R C H A S E TO P
A T T IC IN S U L A T IO N S H IE L D
F IR E S T O P S P A C E R
G A S B -VE N T
P IP E S E C T IO N (S )
Figure 2.2 Typical Vertical Installation
• Read all of the instructions before starting the in-
stallation. Follow these instructions carefully dur-
ing the installation to ensure maximum safety and
benefi t.
WARNING
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
• Installation and use of any damaged appliance or vent
system component.
• Modifi cation of the appliance or vent system.
• Installation other than as instructed by Hearth & Home
Technologies.
• Improper positioning of the gas logs or the glass door.
• Installation and/or use of any component part not
approved by Hearth & Home Technologies.
Any such action may cause a fi re hazard.