Positioning The Logs - Heat & Glo 6000GBV Owner's Manual

E. Positioning the Logs
If the gas logs have been factory installed they
should not need to be positioned. If the logs have
been packaged separately, refer to the following
instructions.
STEP 1.
CAUTION: Logs are fragile! Carefully remove the
logs, grate and supporting cardboard from the
inside of the fi replace See Figure 12.2.
STEP 2.
Place the metal grate on top of the burner.
Position the legs of the grate into the forward set
of indentations in the burner top. Make sure that
grate is all the way forward. See Figure 12.3.
STEP 3.
Log #1 (SRV2103-107):
Place the log on the burner so the cutout in the
log goes around the hump in the burner. The outer
legs of the log should self center on the sides of
the burner. Pull the log forward. The ramp shape
in the bottom of the log sits fully against the ramp
shape molded into the burner. The right side of
log will touch the smaller hump.There will be a
1/4 inch or so gap around the hump. See Figures
12.4 and 12.5.
Figure 12.4 Front View
26
1 1
Heat & Glo • 6000GBV, 6000GBV-IPI • 2104-900 Rev. G • 9/08
Log Assembly: LOGS- 6000G
3 3
2 2
Figure 12.2
HUMP HUMP
Figure 12.3
Figure 12.5 Top View
1 1
4 4
5 5
SMALLER SMALLER
HUMP HUMP
INDENTATIONS INDENTATIONS
1 1
2103-910