Opening Setup Screen; Step 1. Pc (Wired Lan) Setup; Step 2. Connecting - Omron WE70-AP Operation Manual

3-2. Opening Setup Screen

This section describes steps from opening a setup screen for an access point and a client (slave) to checking
communication.

Step 1. PC (Wired LAN) Setup

Configure an IP address through Chapter 2-3. Connection Check, IP Address Setup (P.2-10).

Step 2. Connecting

(1) Connect an access point and PC using a LAN cable.
Always use a straight cable.
(2) Connect power cables of an access point and a client (slave).
(3) Turn their power on and check indication of each POWER indicator as
shown below.
Check the LAN indicator of the access point because it is connected to
PC.
POWER MODE LAN WIRELESS
WE70-AP
INIT
+ –
ETHERNET
24V
To 24VDC Power
Straight LAN Cable
(4) Check if each WIRELESS indicator of the access point and the client
(slave) is on in several seconds (about 8 seconds).Communication will be
started as they have the same SSID and channel in their factory
shipment status.
POWER MODE LAN WIRELESS
Check the light is ON.
Access point
WE70-AP
Chapter 3 Basic Setup
POWER RSSI LAN WIRELESS
PUSH
INIT
+ –
RSSI
ETHERNET
24V
To 24VDC Power
POWER RSSI LAN WIRELESS
Check the light is ON.
3
3-3