AP
■ Maintenance
<Administrator settings> Screen
● ID Setting for administrator
You can configure access control to a setup screen of an access point.
<Apply> Button..................... Clicking this button enables all setup items changed in the "Administrator
<Cancel> Button................... This button resets changed setup items in the "Administrator settings"
(1) Admin. ID ......................... Fixed to "admin".
(2) Admin. Password
..................................... To set a password for an administrator ID, enter the desired alphanumer-
(3) Confirmation Input .......... Enter new password again for confirmation.(Example: ****)
If you forget the administrator password, you will not be able to check the settings.
Caution
In such a case you must reset the unit to its factory shipment status.
(1)
(2)
(3)
settings" screen.
screen to original settings before the change.
Note that the original setting cannot be recovered after <Apply> button is
clicked.
ic characters (within 31 characters) with the attention for capitalization.
Entered character is displayed as "*(asterisk)" or "•(black circle)".
(Example: ****)
If an administrator password is being specified, a user is asked to enter
the password for access. Enter this administrator password.
Chapter 5. Setup Menu
5-15
5