18.1 Overview
This chapter offers some suggestions to solve problems you might encounter. The potential
problems are divided into the following categories.
•
Power, Hardware Connections, and LED
•
NWA Access and Login
•
Internet Access
•
Wireless Connections
•
Resetting the NWA
18.2 Power, Hardware Connections, and LED
The NWA does not turn on. The LED is not on.
Make sure you are using a PoE power injector or PoE switch.
1
Make sure the PoE power injector or PoE switch is connected to the NWA and plugged in to an
2
appropriate power source. Make sure the power source is turned on.
Disconnect and re-connect the PoE power injector or PoE switch.
3
Inspect your cables for damage. Contact the vendor to replace any damaged cables.
4
If none of these steps work, you may have faulty hardware and should contact your NWA vendor.
5
The LED does not behave as expected.
Make sure you understand the normal behavior of the LED. See
1
Check the hardware connections. See the Quick Start Guide.
2
Inspect your cables for damage. Contact the vendor to replace any damaged cables.
3
Disconnect and re-connect the PoE power injector or PoE switch to the NWA.
4
NWA5301-NJ User's Guide
C
HAPTER
Troubleshooting
Section 1.5 on page
1 8
20.
166