ZyXEL Communications NWA5301-NJ User Manual page 49

Table 22 Monitor > Log > View Log (continued)
LABEL
Destination
Address
Source Interface
Destination
Interface
Protocol
Keyword
Search
Email Log Now
Refresh
Clear Log
#
Time
Priority
Category
Message
Source
Destination
Note
The Web Configurator saves the filter settings if you leave the View Log screen and return to it
later.
NWA5301-NJ User's Guide
DESCRIPTION
This displays when you show the filter. Type the IP address of the destination of the
incoming packet when the log message was generated. Do not include the port in this filter.
This displays when you show the filter. Select the source interface of the packet that
generated the log message.
This displays when you show the filter. Select the destination interface of the packet that
generated the log message.
This displays when you show the filter. Select a service protocol whose log messages you
would like to see.
This displays when you show the filter. Type a keyword to look for in the Message,
Source, Destination and Note fields. If a match is found in any field, the log message is
displayed. You can use up to 63 alphanumeric characters and the underscore, as well as
punctuation marks ()' ,:;?! +-*/= #$% @ ; the period, double quotes, and brackets are
not allowed.
This displays when you show the filter. Click this button to update the log using the current
filter settings.
Click this button to send log messages to the Active e-mail addresses specified in the
Send Log To field on the Configuration > Log & Report > Log Settings screen.
Click this to update the list of logs.
Click this button to clear the whole log, regardless of what is currently displayed on the
screen.
This field is a sequential value, and it is not associated with a specific log message.
This field displays the time the log message was recorded.
This field displays the priority of the log message. It has the same range of values as the
Priority field above.
This field displays the log that generated the log message. It is the same value used in the
Display and (other) Category fields.
This field displays the reason the log message was generated. The text "[count=x]", where
x is a number, appears at the end of the Message field if log consolidation is turned on and
multiple entries were aggregated to generate into this one.
This field displays the source IP address and the port number in the event that generated
the log message.
This field displays the destination IP address and the port number of the event that
generated the log message.
This field displays any additional information about the log message.
Chapter 4 Monitor
49