Examples Of Secure Telnet Using Ssh - ZyXEL Communications NWA5301-NJ User Manual

Chapter 12 System

12.5.5 Examples of Secure Telnet Using SSH

This section shows two examples using a command interface and a graphical interface SSH client
program to remotely access the NWA. The configuration and connection steps are similar for most
SSH client programs. Refer to your SSH client program user's guide.
12.5.5.1 Example 1: Microsoft Windows
This section describes how to access the NWA using the Secure Shell Client program.
Launch the SSH client and specify the connection information (IP address, port number) for the
1
NWA.
Configure the SSH client to accept connection using SSH version 1.
2
A window displays prompting you to store the host key in you computer. Click Yes to continue.
3
Figure 78 SSH Example 1: Store Host Key
Enter the password to log in to the NWA. The CLI screen displays next.
12.5.5.2 Example 2: Linux
This section describes how to access the NWA using the OpenSSH client program that comes with
most Linux distributions.
Test whether the SSH service is available on the NWA.
1
Enter "telnet 192.168.1.2 22" at a terminal prompt and press [ENTER]. The computer
attempts to connect to port 22 on the NWA (using the default IP address of 192.168.1.2).
A message displays indicating the SSH protocol version supported by the NWA.
Figure 79 SSH Example 2: Test
$ telnet 192.168.1.2 22
Trying 192.168.1.2...
Connected to 192.168.1.2.
Escape character is '^]'.
SSH-1.5-1.0.0
132
NWA5301-NJ User's Guide