Burner Ignition And Operation - Rinnai GT114PHB Assembly Instructions And Operation Manual

BURNER IGNITION AND OPERATION

For safety, before attempting to ignite any burners, it is important to ensure that
the locks for the castor wheels are 'ON' to prevent the barbecue from moving
IMPORTANT
during use, do this by rotating the locking levers
Turn 'OFF' the locks by rotating the locking levers clockwise.
• DO NOT light the barbecue with the hood or side burner lid closed.
• DO NOT close the side burner lid whilst the side burner is alight.
WARNING
• DO NOT lean over the cooking surfaces whilst lighting the Barbecue.
• DO NOT move the barbecue whilst hot or in operation.
• If burners go out during operation, close the gas supply at the source and turn all burner
controls to 'OFF'. Open the hood and wait at least 5 minutes before attempting to relight.
1. Turn gas 'ON' at the cylinder by opening the gas valve on at the
cylinder and turning it anticlockwise.
Main and Back Burners
Step 1. Push and turn the main burner control knob to the 'HI' position.
Step 2). Press and hold the ignition button on the contol panel.
Step 3). The burner should light within 5 seconds.
Step 4). Release the ignition button.
Step 5). Repeat to check all Main Burners and Back Burner.
Side Burner
Step 1. Push and twist the control knob in an anti-clockwise direction
until it 'clicks'.
Step 2). The burner will should ignite on the first click.
In all cases if any burner fails to light after three attempts,
turn all control knobs to 'OFF', ensure that all hoods are
WARNING
opened and wait 5 minutes. Then repeat the lighting
procedure. If a flame can not be achieved on any individual
burner, check that burner for obstructions.
If ignition can still not be achieved refer to "TROUBLE
SHOOTING" on page 38.
2. Checking Burner Flame:
Main Burners
Check each burner individually, with a 'HIGH' flame established the
burner flame is approximately 2cm tall and emanating around the
perimeter of the burner tube, the flame should be generally 'blue' in
appearance.
Side Burners
With 'HIGH' flame established on the side burner check that the burner flame is approximately 2cm tall and
emanating around the perimeter of the burner ring, the flame should be generally 'blue' in appearance.
3. If a burner flame cannot be achieved, perform the Ignition System Tests on page 26. If ignition system is
satisfactory and a burner flame can still not be established contact Rinnai.
ABNORMAL FLAME CHARACTERISTICS
Main and Side Burners
WARNING
Excessive yellow flame, irregular size or wafty flame, 'popping' of the flame,
sooting, black smoke, hissing sounds or other abnormal noises may indicate
incorrect assembly or a defect.
Rinnai Australia
TESTING
A
anti-clockwise.
- 27 -
A
HI / IGNITION
POSITION
Burner Tube
CLICK !
Sparker is located
under Burmer Tube
Burner Tube
Spark Electrode Tip Spark Receiver
Spark Gap 4-5mm
GT Range BBQ Owner's Operation Manual
CASTOR
LOCK
A