Side Burner - Rinnai Coastal Customer's Operating And Assembly Instructions

12
INSTALLING THE SIDE BURNER
1. Insert the valve orifice through the orifice support
bracket on the left front shelf bracket and into the
side burner opening.

Side burner

opening
Valve
orifice
2. Attach the front panel with the valve stem going
through the front opening. Ensure the folded edge
is resting on top of the bottom fold of the side shelf.
Secure the valve and control knob seat to front
panel with screws. Connect the ignition wire from
barbecue body to the ignition wire of electrode
Front
panel
Control
knob seat
Control
knob
Ignition wire
connection
A S S
Orifice support
bracket
Side Orifice Valve
burner support orifice
bracket
assembly.
Ensure the folded
edge is resting on
top of the bottom
fold of the side shelf
Ignition wire from
barbecue body
E M B L Y
IGNITION BATTERY INSTALLATION
1. Unscrew the igniter cap located on the control
panel and remove the contact and spring from the
igniter slot.
2. Place the supplied AA battery into the igniter slot
with the positive pole facing toward you.
3. Place the
with contact over
the battery. Screw
the igniter cap back
onto the
panel.
MAIN BURNER ELECTRODE CHECK
Continuous igniter
Gas
valve
Orifice
Burner control
Before placing the cooking components into your
barbecue body, ensure that the spark electrode tip is
properly positioned within each gas collector box (a
stainless steel mechanism found at side of burner. The
easiest way to ensure this is to perform the following
electrode check:
1. Be sure all control knobs are set to 'OFF'. Open the
barbecue hood. NEVER put your face inside the
barbecue body.
2. Push the piezo igniter or continuous ignition button
and look down at the gas collector box. If a spark
is present the electrode tips are properly positioned.
3. After correct spark gap has been verified and there
is still no spark evident, check that the ignition lead
is firmly attached to the spark electrode and ignition
source.
4. If no spark is seen, then the spark gap shown below
may need to be adjusted as follows:
The gap between the spark electrode tip and spark
receiver should be approximately 5 mm.
If the gap is wider the 5 mm use a pair of long nose
pliers and gently bend the end of the gas collector
box in or out to adjust to the correct gap.
5 mm spark gap
spring
Contact
control
AA
Igniter
battery
cap
Spring
Gas collector box
Spark electrode Burner
Burner tube
Inside nut
Spark electrode tip
12
Screw
Burner port
Foot