Table of Contents
Advertisement
12
IGNITION BATTERY
AA
battery
Igniter
cap
Contact
BACK BURNER SPARK ELECTRODE TEST
AND ADJUSTMENT – 5012 model
Product shipping can reposition the rotisserie burner
spark electrode. If your barbecue and side burner are
completely assembled and this rotisserie burner
electrode does not continuously spark, then conduct
this adjustment
.
Do not touch the
white ceramic
electrode insulator
1.
Turn the gas supply off at the gas cylinder.
2.
Be sure the AA battery is installed and ensure the
connections are secure.
3.
Push the ignition button and watch for a small blue
spark at the rotisserie burner electrode tip. If there is
no spark you must adjust the gap between the
electrode tip and the stainless steel rotisserie burner
screen. The gap should be adjusted to approximately
5 mm or closer.
4.
Adjust the gap using needle nose pliers. DO NOT
adjust the gap by hand or touch the white ceramic
electrode insulator. Using one set of needle nose
pliers, securely hold the electrode as shown above.
With another set of pliers, gently bend the tip
end of electrode to within 5 mm of the stainless
steel screen. Be careful not to puncture the screen or
break electrode tip.
5.
Try spark electrode test again. Re-adjust if necessary.
I
N
S
P
Spring
5 mm
E
C
T
I
O
BURNER OPERATION
AND IGNITION SYSTEM CHECK
Piezo igniter
Gas valve assembly
1.
With burner controls in 'OFF' position, open the gas
cylinder valve or connect to gas supply.
2.
Upon first assembly the gas lines and burners will
be full of air. In order for the burners to light
properly the lines must fill with gas. It may require
several attempts at lighting the burners before you
are successful.
3.
Push the igniter button and check for sparking at
the stainless steel gas collector, located adjacent to
each burner.
4.
If a spark is not evident at the gas collector, check
that the ignition lead is firmly attached to the spark
plug.
5.
With sparking established at collector box, turn the
burner control to 'HI' to establish a flame on the
burner.
6.
Push and turn the required burner control as
required in an anti-clockwise direction to the 'HI'
position. Cross lighting channels inside the barbecue
body enables the flame to transfer across to the
centre and opposite side burners to ignite them.
7.
If any burners fail to light after several attempts,
turn off gas supply at source.
Wait until burners cool and inspect for obstructions to
gas flow. See also Safety instructions (pages 3, 4), Lighting
and Operating instructions (pages 14, 15).
N
Gas collector /
electrode
Orifice
Burner tube
12
Advertisement
Table of Contents
