IBM RS/6000 User Manual page 98

Press Enter when you are finished; you must type the password again for verification.
Verify Password
If the two password entries do not match, an error icon displays with a message:
Password was attempted to be set and an error code Power-On Access: 20E00000
displays.
Note: If you forget the Power-On Access password, you can erase the password by
A password becomes effective only after the system is turned off and back on again.
Remote Mode: The remote mode, when enabled, allows the system to start from the
defined boot device. This mode is ideal for network servers and other system units that
operate unattended. When the remote mode is set, the icon label changes to Remote
<On>.
Note: To use the remote mode feature for booting unattended devices, you must
82
User's Guide
shutting down the system unit and removing the battery for at least 30 seconds.
enable the unattended start mode. See the "System Power Control Menu" on
page 48 for instructions on enabling the unattended start mode, which allows the
system unit to turn on whenever ac power is applied to the system (instead of
having the system unit wait for the power button to be pushed).