Call-Out Policy Setup Menu - IBM RS/6000 User Manual

For digital pagers that require a personal identification number (PIN) for access,
include the PIN in this field as shown in the following example:
18001234567,,,,87654
The commas create pauses for the voice response system, and the 87654
represents the PIN. The length of these pauses is set in modem register S8. The
default is usually 1 or 2 seconds each.
v Customer Voice Telephone Number is the telephone number of a phone near the
server or answered by someone responsible for the server. This is the telephone
number left on the pager for callback. For test purposes, use a test number, which
you can change later.
v Customer System Telephone Number is the telephone number to which your
server's modem is connected. The service or administration center representatives
need this number to make direct contact with your server for problem investigation.
This is also referred to as the call-in phone number.

Call-Out Policy Setup Menu

This menu allows you to set call-out policy.
1. Call-Out policy (First/All):
2. Remote timeout, (in seconds):
3. Remote latency, (in seconds):
4. Number of retries:
98. Return to Previous Menu
1>
v Call-Out Test
The Call-Out Test verifies if the Call-Out function is working properly. Before the Test,
call-out must be enabled and the system configured properly for call-out.
During the setup, the user should have entered the phone numbers for the Digital
Pager and Customer Voice for test purposes. These numbers are used to determine
whether call-out is working during the Call-Out Test.
The Call-Out Test should cause the user's phone to ring. If the test is successful,
call-out is working properly. The user should now change the test Digital pager and
Customers Voice number to the correct numbers.
processor to retry, continuing to place pager calls for the number of retries
specified in the Call-Out policy Setup Menu. These retries result in redundant
pages.
Call-Out Policy Setup Menu
Currently First
Currently 120
Currently 2
Currently 2
Chapter 3. Using the Service Processor
57