IBM RS/6000 User Manual page 168

Keyboard Type
Kanji keyboard. Identify by the Japanese
characters.
ASCII–terminal keyboard. This applies to all
attached terminals.
Step 11
1. If the terminal type has not been defined, use the Initialize Terminal option on the
Function Selection menu to initialize the operating system environment before you
can continue with the diagnostics. This is a separate and different operation from
selecting the console display.
2. Select Diagnostic Routines.
3. Press the Enter key.
4. In the following table, find the menu or system response you received when you
selected Diagnostics. Follow the instructions given in the Action column.
System Response
The Diagnostic Mode Selection menu is
displayed.
The Missing Resource menu is displayed.
The New Resource menu is displayed.
The system does not respond to selecting
diagnostics.
152
User's Guide
Action
Record error code M0KBD003 and report the
problem to the service organization.
Go to the problem-determination documentation
for this type of terminal.
Action
Select Problem Determination and go to "Step
12" on page 153.
Follow the displayed instructions until either the
Diagnostic Mode Selection menu or an SRN is
displayed.
If the Diagnostic Mode Selection menu is
displayed, select Problem Determination and go
to "Step 12" on page 153.
If you get an SRN, record it, and go to "Step
14" on page 153.
Follow the displayed instructions.
Note: Devices attached to serial ports S1 or
S2 do not appear on the New Resource menu.
Also, ISA adapters do not appear unless they
have been identified and configured.
If the Diagnostic Mode Selection menu is
displayed, select Problem Determination and go
to "Step 12" on page 153.
If you get an SRN, record it, and go to "Step
14" on page 153.
If you do not get an SRN, go to "Step 17" on
page 154.
Go to "Step 10" on page 151.