Language Selection Menu - IBM RS/6000 User Manual

v The following is an example of the Memory Configuration/Deconfiguration Menu:
DIMMs on memory card number 0:
DIMMs on memory card number 1:
1. Configured by system (0x0)
2. Configured by system (0x0)
98. Return to Previous Menu
Enter card number _and_ DIMM number separated by a space
1>
The user can manually configure or deconfigure any memory DIMM (Dual Inline
Memory Module), regardless of failure status, through this Service Processor menu.
The configuration process takes place during the system power-up. Therefore, the
configuration displayed in STANDBY mode reflects the configuration during the last
boot.
To view the current configuration, access the Service Processor menu after the
system starts. When the user selects a memory DIMM, its state will toggle between
configured and deconfigured. Memory DIMMs that are not present are not listed. A
memory DIMM can be in any of the following four states:
– Configured by system: The memory DIMM is present, and has not exceeded the
number of failure threshold. It is configured by the system and is available.
– Deconfigured by system: The memory DIMM is present, but has exceeded the
number of failure threshold. It is deconfigured by the system and is currently
unavailable.
– Manually configured: The memory DIMM is present and available. It is
configured by the user through the service processor menus.
– Manually deconfigured: The memory DIMM is present, but unavailable. It has
been deconfigured by the user through the service processor menus.

Language Selection Menu

The service processor menus and messages are available in various languages. This
menu allows selecting languages into which Service Processor and system firmware
menus and messages are displayed.
1. English
2. France
3. Deutsch
4. Italian
5. Espanol
6. Svenska
98. Return to Previous Menu
99. Exit from Menus
1>
Memory Configuration/Deconfiguration Menu
LANGUAGE SELECTION MENU
Chapter 3. Using the Service Processor
53