IBM RS/6000 User Manual page 100

If the two password entries do not match, an error icon displays with a message:
Password was attempted to be set and an error code Privileged Access: 20E00001
displays.
If you previously had set a privileged-access password and want to remove it, select
the Remove icon.
After you have selected the remove icon. The privileged-access status icon flashes and
changes to the unlock position to indicate that the privileged-access not set.
Note: After you have entered and verified the password, the privileged-access
Attention:
been enabled, you are asked for the privileged-access password at startup every time
you boot your system.
Spin Delay
Select this icon to change the spin-up delay for SCSI hard disk drives attached to your
system. Spin-up delay values can be entered manually or you can use a default setting.
All values are measured in seconds. The default is two seconds. After you have entered
the new Spin-up delay values, use the arrow keys to highlight the Save icon and press
Enter.
84
User's Guide
password icon flashes and changes to the locked position to indicate that your
system unit now requires the password that you just entered before running
system programs.
If no user-defined bootlist exists and the privileged-access password has