When This Message Appears - Toshiba e-Studio2505 User Manual

6 TROUBLESHOOTING

When This Message Appears

A message appears when a problem occurs on the equipment. Find the message on the list below and follow the
instructions in the Countermeasure.
Message
MISFEED xxx
CLOSE ***
DRAWER * EMPTY
COUNT OVER
CALL FOR SERVICE
TIME FOR MAINTENANCE
BYPASS EMPTY
TONER IS LOW
ERROR : TONER
TONER EMPTY
MEMORY IS FULL
CLEAR PAPER OUTPUT
TRAY:
PRESS START KEY
92

When This Message Appears

Meaning
An original or a sheet of copy paper is
misfed. An error code "xxx" and a
message for solving the problem are
displayed.
Any cover of the equipment indicated
by "***" is not securely closed.
The paper in a drawer indicated by "*"
has run out.
The number of pages scanned has
exceeded the maximum value.
The repair or adjustment by your
service technician is needed.
The maintenance by your service
technician is needed.
Paper set on the bypass tray has run
out.
There is only a little toner remaining in
the toner cartridge.
The toner cartridge is not installed
correctly.
The recommended toner cartridge is
not being used.
The toner in the toner cartridge has
run out.
The built-in memory of the equipment
has become full.
Approx. maximum sheets of paper
have continuously exited and the
equipment stops copying to prevent
the copied paper from overflowing
from the tray.
Countermeasure
Remove any misfed paper.
P.93 "Paper Misfeed"
Close the cover securely.
Load paper in the drawer.
P.17 "Loading paper in the drawer"
Select "PRINT" on the LCD screen to copy the data scanned
so far. Select "CANCEL JOB" to delete all the data scanned so
far.
Contact your service representative.
Give the service technician the error code (consisting of
letters and numbers) that appears in the upper right area of
the LCD screen.
Never attempt to repair, disassemble or modify the
equipment by yourself.
This could cause an electric shock, a fire or serious injury.
Contact your service representative when the equipment is in
an abnormal condition or any malfunction is found.
Contact your service representative.
Load paper on the bypass tray.
P.19 "Loading paper on the bypass tray"
There is still a little toner remaining in the toner cartridge. Do
not replace the toner cartridge until "TONER EMPTY" appears
on the LCD screen.
The message may not appear because the toner
remaining in the cartridge does not lie evenly.
When the message appears, it is advisable to
purchase a new recommended cartridge to prepare
for its replacement.
Install the toner cartridge correctly.
If you are using a toner cartridge other than the one we
recommend, the equipment may not be able to detect whether
it is installed or not. For details of the recommended toner
cartridge, refer to the Safety Information.
Replace the toner cartridge with a new one.
P.98 "Replacing Toner Cartridge"
Select "PRINT" on the LCD screen to copy the data scanned
so far. Select "CANCEL JOB" to delete all the data scanned so
far.
Remove the paper from the receiving tray, and then press
[START] to resume copying.
Press [CLEAR/STOP] to end the copy. When "MEMORY
CLEAR?" appears on the LCD screen, select "YES", and then
press [START].