Client Router (Wisp) - Planet WNAP-7350 User Manual

User Manual of WNAP-7350
WDS Repeater Mode
WNAP-7350
Internet
a/n a/n
Client
Antenna
Antenna
PoE
WDS Repeater Mode
Clients
Switch
1. Connect the LAN port of the WNAP-7350 to the POE port of the PoE Injector over an Ethernet cable.
2. Connect the PC to the LAN port of the PoE Injector over an Ethernet cable.
3. Plug one end of the power cord into the PoE Injector, and the other end in electrical socket.
4. Go to "Advanced-> Operation Mode" to configure it to AP Bridgemode.
Figure 5-3-19
In this mode, the wireless interface of the WNAP-7350 works as the WAN port.
To configure the Wireless Settings of AP Bridge Mode, please refer to the section 5.6 Wireless Settings.
5.3.3.3.

Client Router (WISP)

In the Client Router mode, the WNAP-7350 has DHCP Server build inside that allows many LANs automatically
generate an IP address to share the same Internet. Connect an AP/WISP wirelessly and connect to LANs via
wired. The Client Router mode is acts completely opposite to the AP Router mode.
WISP Mode
Internet
WNAP-7350
Client
a/n
a/n
Antenna
Wireless Internet
LAN
Service Provider
WISP Mode
-38-