Settings; Ringer And Alert Setting; Amplify - Geemarc SCREENPHONE User Manual

SETTINGS

Ringer and Alert Settings
Ringer Volume
A switch located on right side allows the ringer to be switched OFF, LOW
or HIGH.
Your telephone is pre-set with the ringer switched to HIGH.
OFF HIGH
LOW
Strobe
A switch located at the rear allows the flash strobe to be switched ON or
OFF.
Your telephone is pre-set with the strobe switched to ON.
When switched ON, the bright strobe light flashes when you receive a
telephone call.
LCD Screen Contrast
A switch located on right side allows the screen contrast to be altered.
This will alter the contrast between the text on screen against the
backlighting. There are three levels of contrast for selection.
LOW HIGH
MEDIUM
15
SETTINGS

Amplify

A switch located at the rear allows the amplification facility to be switched
ON or OFF.
Your telephone is pre-set with the Amplify swith at the OFF Postion.
Amplify Switch at ON Position
The additional amplification and tone controls are automatically activated
each time you use the telephone. The LED light next to the amplify button
will be lit. You can still turn the amplify feature off at any time, simply
press the amplify button on the front of the telephone.
Amplify Switch at OFF Position
The additional amplification and tone controls are off by default each time
you use the telephone. The LED light next to the amplify button will not be
lit. You can still turn the amplify function on at any time, simply press the
amplify button on the front of the telephone.
Your telephone is pre-set with amplification switched to OFF and handset
volume to Minimum. See Volume and Tone section in the Using the
Telephone chapter for more detail.
Voice Announcement
A switch located on the right side of the telephone allows the voice
announcement to be switched ON or OFF. The message is a pre-set
factory message; you are not able to change it.
When this function is "ON" the phone will inform people who are calling on
a standard voice telephone, without the 18002 prefix, that you are using
Voice Carry Over or a textphone. It will instruct them to call again using
the prefix 18002. The message is as follows " Please dial 18002 before
number".
If you are new to using Voice Carry Over or Typetalk, and will not be using
this telephone as a standard telephone, it is recommended that this
function is turned "ON". If you are confident that anyone who calls you will
remember the 18002 prefix then this can be turned 'OFF'.
16