Geemarc Dallas 10 User Manual

Geemarc Dallas 10 User Manual

Geemarc telephone user guide
Hide thumbs Also See for Dallas 10:

Advertisement

D D D D D ALLAS 10
ALLAS 10
ALLAS 10
ALLAS 10
ALLAS 10

User guide

If you are using this telephone with a hearing aid, set your
hearing aid to the «T» setting

Advertisement

Table of Contents
loading

Summary of Contents for Geemarc Dallas 10

  • Page 1: User Guide

    D D D D D ALLAS 10 ALLAS 10 ALLAS 10 ALLAS 10 ALLAS 10 User guide If you are using this telephone with a hearing aid, set your hearing aid to the «T» setting...
  • Page 2: Connecting Telephone

    SETTING UP 1 - CONNECTING TELEPHONE 1 - Connect the handset cord. 2 - Connect the line cord to the socket located at rear of telephone then connect the PTT plug*.
  • Page 3: Ringer Settings

    On ( ) or Off ( 3 - WALL MOUNTING To wall-mount your telephone,slide out the clip turn around and slide back into the wall mounting posi- tion (located in the base unit, just below the ear piece).This will ensure that the handset stays firmly in position.
  • Page 4: Using The Phone

    USING THE PHONE 1 - ANSWERING INCOMING CALL - When an incoming call is received the phone will ring and flash. To answer the call lift the handset and speak. - On completion of the call, carefully replace the handset in the cradle to release the line. 2 - VOLUME RECEIVING ADJUSTMENT You can increase the volume according to your own hearing requirements.
  • Page 5: Making A Call

    USING THE PHONE 3 - MAKING A CALL - Lift the handset. - Await the dial tone and dial required number. - On completion of the call, carefully replace the handset in the cradle. 4 - SENDING LEVEL ADJUSTMENT If your voice is quiet or called parties have difficulty hearing you, you can increase the sending level volume with the switch located on the right...
  • Page 6: Storing Telephone Numbers

    (16 digits maximum for each memory). - Lift the handset. - Press button. - Dial the telephone number you wish to store. - Press button. - Press one of the direct memory buttons, M1, M2, Or press MEM and any button 0 to 9 on the key pad under which you wish to store the telephone number in indirect memory.
  • Page 7: Dialling Stored Number

    USING THE PHONE Note : Numbers will be lost if you disconnect your phone. Entering a new number in memory will automatically erase the previous number. 8 - DIALLING STORED NUMBER - Lift the handset and await the dial tone. - Press appropriate direct memory button M1, M2, or M3.
  • Page 8 OF A WARRANTY CLAIM Please note: The guarantee applies to the United Kingdom only. Declaration : Hereby Geemarc Telecom SA declares that this product is in compliance with the essential requirements and other relevant provisions of the Radio and Telecommunications Terminal Equipment Directive 1999/5/EEC and in particular article 3 section 1a, 1b and section 3.

Table of Contents