Installation; Connection/Setting Up - Geemarc SCREENPHONE User Manual

DESCRIPTION
Icons on your screen display
All the icons below are displayed in the 'Icon Area' (bottom right hand
corner) on the screen.
TEXT
This shows that the the telephone is in text mode
VOICE
This shows that the the telephone is in voice mode
Note: The phone can only be in one mode at any time.
Mute is activated
One or more voice messages have been received (relayed to text).
When the telephone is operating under battery power, the full icon is
shown if the battery is full. If the battery is starting to run down, only the
outline and the lower square is shown. It will be soon be time to install
some new batteries
When the telephone is operating under AC power and the batteries are flat
or not installed, only the outline of the battery is shown flashing. It is time
to install some new batteries.
11

INSTALLATION

Connecting/Setting Up
Connect the handset cord. Insert one end of the cord into the handset, the
other into the telephone base – left side.
Open the battery compartment.
Insert 4 good quality alkaline batteries (AA size, 1.5V type, not supplied)
into the battery compartment located on the base of the telephone.
Replace the battery cover.
Note: Do not use rechargeable batteries. Do not put batteries into the
household rubbish, pay attention to battery regulations regarding battery
disposal.
Insert the line cord into the socket located at the rear of telephone
.
then connect the plug at the the other end of the cable
into the wall socket
12 10