Text Only Calls - Geemarc SCREENPHONE User Manual

USING THE TELEPHONE
Telephone is now in TEXT mode
D
SCREENPHONE User awaits response.
This will appear in the form of a typed
message on the screen
Follow steps A, B, C, D each time you wish
to speak
At the end of the conversation, the
Operator sends the following
Message to the SCREENPHONE User:
SK = Stop Keying
SCREENPHONE User can now end the
call by replacing the handset
Note: When switching from "voice" mode to "text" mode there may be a
delay before the operator starts typing. You should avoid returning to
voice mode again before the operator says "GA" (go ahead) – this
indicates that the person you are calling has stopped talking.
SK
25
USING THE TELEPHONE

Text Only Calls

You can also use this telephone to send typed messages (as well as
receive them) via the Typetalk operator with an optional Geemarc
keyboard.
This plugs into the keyboard socket at the rear of the telephone.
Making a Text Only Call
ACTIONS
Pre-dial the number, with the handset in the
cradle.
You must use the prefix 18001 if you
require the Typetalk operator. This can be
entered using one of the following methods:
manually using the keypad
pressing the "18001" button on the
telephone base.
Pulling a number from the phonebook
with 18001 already added.
The telephone number must include full
area code.
Lift the handset
The telephone automatically switches to
Text mode as 18001 has been dialled.
You will receive the following messages in
the main area:
ON SCREEN DISPLAY
TXD Ringing
TXD Ringing
TXD Connecting
Typetalk Operator
TXD operator
Connected, please
wait
26