Parallel Installation; Corner Installation; Wall And Ceiling Clearances; Hearth Requirements - Vermont Castings RADVTCB Homeowner's Installation And Operating Manual

Parallel Installation:

Minimum Clearance and Flue Centerline
48"
(1220mm)
Max. Alcove
Depth
6"
(150mm)
ST130
Fig. 3 Parallel installation, minimum back and side clear-
ances, and flue centerlines.

Corner Installation:

Minimum Clearance and Flue Centerline
(457mm)
18"
(457mm)
6"
(150mm)
Fig. 4 Corner installation, minimum corner clearances and
flue centerline.
30004967
42" (1070mm)
Min. Alcove Width
4" (102mm)
6"
(150mm)
18"
6"
(150mm)
Wall Centerline from Floor
Direct Vent Only
Effective Minimum
Centerline
Fig. 5 Minimum wall centerline.

Wall and Ceiling Clearances

Direct Vent Only
ST19
A: Rear Wall
B: Min. Clearance
C: Min. Alcove Height
ST101b
D: Max. Alcove Depth
Stardance
Sidewall Clearance Direct Vent
Min. Clrnc
* needed for installing DuraVent Minimum Vent Kit #79 or
Vermont Castings Group Minimum Vent Kit #7TFSMSK. 9/28/00 djt
Fig. 6 Dimensions and clearances to ceiling or alcove.
The Radiance Heater must be installed on rigid flooring.
When the heater is installed directly on any combustible
surface other than wood flooring, a metal or wood panel
extending the full width and depth of the unit must be used
as the hearth. There are no other hearth requirements.
Radiance Direct Vent Gas Heater
®
A
A
57" (1448 mm)
(Vermont Castings Group Pipe)
55" (1399 mm) (DuraVent Pipe)
ST131b
Stardance
wall thimble
9/28/00 djt
D
B
C
A
4" (10 mm)
44" (1118 mm)*
7" (1830 mm)*
48" (10 mm)
6" (150 mm)

Hearth Requirements

ST131b
ST101b
7