Vermont Castings RADVTCB Homeowner's Installation And Operating Manual page 27

. Install the rear log by placing it
on the ember bed toward the
back of the firebox. (Fig. 48) The
log should touch the back wall
of the firebox. When the log is
in place, the two () notches on
the bottom of the log rest on the
two () ribs on the back side of
the ember bed. (Fig. 49)
Figure 49
3. Install the front left and right logs
(Fig. 50) by placing them on the
ribs shown in Figure 49. Make
sure the logs line up with the flat
spots on the ember bed intended
for location purposes. (Fig. 49)
4. Install the left cross log by engag-
ing the hole on the bottom with the
pin on the left side of the rear log.
Set front side of cross log on notch
in ember bed. (Fig. 51)
5. Install the right cross log by engag-
ing the hole on the bottom with the
pin on the right side of the rear log.
Set front edge of cross log on em-
ber bed as shown in Figure 51.
30004967
Figure 48
Ribs for Rear Log
Rib Flat Spot for
Front Left Log
Figure 50
Front Left Log
Radiance Direct Vent Gas Heater
®
Ember Bed
LG487
Rib and Flat Spot
for Front Right Log
Front Right Log
Rear Log
LG488
LG489
7