D Direct Code Entry - Icom iF34GT Instruction Manual

D Direct code entry

q While in the standby condition, push [P3] (TX Code Enter)
to enter the TX code edit mode.
• Editable code digit blinks.
w Push [P3] (TX Code Enter) to select the desired digit to
be edited.
• Editable digit differs according to the setting.
e Set the desired digit using [CH Up]/[CH Down]/[TX Code
CH Up]/[TX Code CH Down] or 10-keypad.
r Push [P3] (TX Code Enter) to set the digit, then the digit
to the right will blink automatically.
• When the 10-keypad is used for setting, the digit to the right will
blink automatically without pushing [P3] (TX Code Enter).
t Repeat e and r to input all allowable digits.
y Push [P0] (Call) or [PTT]* to call.
* PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and " " is displayed during each call. However, an
error beep sounds and "
answer back is received after the calls.
" is displayed when no
u Push [PTT] to transmit; release to receive.
i Push [MONITOR] (Moni(Audi)) to send the 'Clear down'
signal.
For your information
When the "UpDate" setting for the call code is enabled, the
set code is overwritten into the call code memory.
4
BIIS OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
19