Connecting Dc Power Supply - Planet WGSW-24040 User Manual
24-port 10/100/1000mbps layer 2 managed switch
Hide thumbs
Also See for WGSW-24040:
- User manual (328 pages) ,
- Quick installation manual (16 pages) ,
- Quick installation manual (12 pages)
Table of Contents
Advertisement
2.2.4 Connecting DC Power Supply – WGSW-24040R / SGSW-24040R
The WGSW-24040R and SGSW-24040R support -48VDC power input, connect the power cable to the switch at the input
terminal block.
1.
The size of the two screws in the terminal block is M3.5.
2.
The terminals are marked "-48V", "FG".
3.
Loosen the two screws so you can slide the DC cable beneath it. Insert the DC cable into the connector first, and screw it
down tight.
4.
Connect the power cable to the DC power supply. After power up or reset, the Managed Switch performs a cold start
procedure.
Before connect the DC power cable to the input terminal block of Managed Switch, ensure that the
Warning:
power switch in the "OFF" position and the DC power is OFF
User's Manual of WGSW-24040 / WGSW-24040R
Figure 2-16 -48VDC connector
31
SGSW-24040 / SGSW-24040R
Advertisement
Table of Contents
