Rack Mounting - Planet WGSW-24040 User Manual

Supply power to the Managed Switch.
Step5:
Connect one end of the power cable to the Managed Switch.
Connect the power plug of the power cable to a standard wall outlet.
When the Managed Switch receives power, the Power LED should remain solid Green.

2.2.2 Rack Mounting

To install the Managed Switch in a 19-inch standard rack, please follows the instructions described below.
Place the Managed Switch on a hard flat surface, with the front panel positioned towards the front side.
Step1:
Attach the rack-mount bracket to each side of the Managed Switch with supplied screws attached to the package.
Step2:
Figure 2-12 shows how to attach brackets to one side of the Managed Switch.
Secure the brackets tightly.
Step3:
Follow the same steps to attach the second bracket to the opposite side.
Step4:
After the brackets are attached to the Managed Switch, use suitable screws to securely attach the brackets to the
Step5:
as shown in Figure
Figure 2-12 Attach brackets to the Managed Switch.
You must use the screws supplied with the mounting brackets. Damage caused to the parts by
using incorrect screws would invalidate the warranty.
2-13.
User's Manual of WGSW-24040 / WGSW-24040R
27
SGSW-24040 / SGSW-24040R
rack,