Alarm Sound Type - Honeywell Xenon 1900 User Manual

alarm duration, scan the appropriate bar code below and then set the time-out
duration (from 0-3000 seconds) by scanning digits on the
inside the back cover, then scanning Save. Default = 0 sec (no alarm).
Base Alarm Duration
Note: If you are out of range when you scan a bar code, you will receive an error
tone even if you do not have the alarm set. You receive the error tone
since the data could not be communicated to the base or the host.

Alarm Sound Type

If you have set the out-of-range alarm enabled, you may change the alarm
type for the scanner or base by scanning the appropriate bar code below
and then scanning a digit (0-7) bar code and the Save bar code on the
Programming Chart
The sounds are as follows:
Setting
0
1
2
3
4
5
6
7
Base Alarm Type
3 - 12
inside the back cover of this manual. Default = 0.
Sound
3 long beeps, medium pitch
3 long beeps, high pitch
4 short beeps, medium pitch
4 short beeps, high pitch
single chirps, medium pitch
2 chirps, then 1 chirp, medium pitch
single chirps, high pitch
2 chirps, then 1 chirp, high pitch
Programming Chart
Scanner Alarm Duration
Scanner Alarm Type