Resetting The Custom Defaults: All Application Work Groups; Using The Scanner With Bluetooth Devices; Pcs/Laptops - Honeywell Xenon 1900 User Manual

To see what the factory default settings are, refer to the table of
Commands, beginning on page 11-5. The standard product default settings for
each of the commands are indicated by an asterisk (*).
Note: Scanning this bar code also causes both the scanner and the base to
perform a reset and become unlinked. The scanner must be placed in its
base to re-establish the link. Refer to
additional information.
If your scanner is in multiple scanner mode, you will hear up to 30
seconds of beeping while all scanners are re-linked to the base and the
settings are changed.
Resetting the Custom Defaults:
All Application Work Groups
If you want the custom default settings restored to all of the work groups, scan
the Custom Product Default Settings bar code below. (If there are no custom
defaults, it will reset the work groups to the factory defaults.) See
Custom Defaults
Note: Scanning this bar code also causes both the scanner and the base to
perform a reset and become unlinked. The scanner must be placed in its
base to re-establish the link. Refer to
additional information.
If your scanner is in multiple scanner mode, you will hear up to 30
seconds of beeping while all scanners are re-linked to the base and the
settings are changed.

Using the Scanner with Bluetooth Devices

The scanner can be used either with the CCB01-010BT charge base or with
other Bluetooth devices. Those devices include personal computers, laptops,
PDAs, and Honeywell mobility systems devices.

PCs/Laptops

Scanning the Non-Base BT Connection bar code below allows the scan-
ner to be used with other Bluetooth devices (e.g., PC/laptop). After you
scan the bar code below, follow the instructions supplied with your Blue-
tooth device to locate the scanner and connect to it. If you go out of range
3 - 24
on page 1-9 for further information about custom defaults.
Custom Default Settings:
All Work Groups
Scanner Modes, page 3-10 for
Scanner Modes, page 3-10 for
Menu
Setting